All Broadley-James dissolved oxygen sensors are available with optional right angle connector. This low profile design provides:

Protection against cable fatigue
Improved grip for sensor extraction
Increased clearance between vessels

Specification

Features:

316L Stainless Steel
Serialized for traceability
RA32 finish with electropolish on wetted parts
Internal and external silicone o-rings
Secured retainer ring

The internal seals of an Oxyprobe are all mechanical seals using o-rings. There are no adhesives to leak or fail in process, making this a more rugged and reliable sensor. Replacing the cathode is also much easier and faster since there is no sealant to clean from the threads. No sealant also makes the job of replacing the cathode much faster and cleaner.

O-rings: AG-SR15
Membrane Cartridges: Single, Four and 25 piece Cartridge Kits

How to choose a sensor

Confirm the entry site is a standard 25 mm port.
Determine how far the sensor should extend into the vessel. For most process media, the minimum length is optimal. However, if the media is viscous and tends to coat the inner wall of the vessel, a longer length may provide better performance.
Decide whether a right angle connector is preferred over a straight connector.
Choose cable length and connector. All D.O. sensors require cable and connector assemblies.

Standard 25 mm OxyProbe with Straight Connector

Sensor Model	Sensor Length	Typical Insertion Length	Sensor Part Number
D400	70 mm	35 mm (1.4″)	D400-B070-PT-D9
D400	150 mm	115 mm (4.5″)	D400-B150-PT-D9
D400	220 mm	182 mm (7.2″)	D400-B220-PT-D9
D400	320 mm	278 mm (10.9″)	D400-B320-PT-D9
D400	420 mm	374 mm (14.7″)	D400-B420-PT-D9